Application Process

Firstly prepare surface 

Clean and dry  the surface. 

Mould needs to be treated with bleach and rinsed with fresh water then. 

All surface defects need to be filled with a suitable filler.

 Using masking tape on wall and ceiling paints is not recommended.

Applying on new work

Apply Taubmans 3 in 1 once on surfaces such as timber,  masonry and paper faced plasterboard.

If surfaces previously painted

All flaking and loose paint need to be removed. Then sand with fine paper surfaces. Prime before paint if it is necessary. Apply Taubmans 3 in 1 to make sure surfaces are even. Undercoat surfaces which were painted before. 

Application steps

Check colour before use. 

Applying two coats using a 4mm – 6mm (nap or pile length) roller or brush is recommended. 

Put thin coats as a thick coat will cause runs to appear. 

Use a roller (10 mm) in a large areas  and brush on the edges.

Mix paint for 5 minutes before use

30 minutes is a Drying time (touch dry)

After 2 hours at 25°C and  4 hours in cold or humid areas Recoat 

If temperatures below 10°C Do not paint

Covered area

Coverage depends on the surface roughness. Up to 16 m2 per litre.