Dan's Paint Cosmocoat Voda Enamel Gloss 10L

Dan's Paint Cosmocoat Voda Enamel Gloss (interior and exterior) is packed full of features, including superior hiding power, excellent coverage, washability, mould-resistant additives, low odour, fast drying times, and low roller spatter, making it excellent value for money. Dan's Paint Cosmocoat Voda Enamel Gloss is available in white and is tintable to most colours (WHITE BASE) using Dan's Paint Easy Colour Tinting Range.

DANS Paint can be tinted to any brand colour only in White Bases

Surface preparation:

• Ensure the surface is clean and dry, free from grease, dirt and dust. All flaking, peeling and loose material must be removed. Cracks and holes should be filled and sanded to an even finish. Sand glossy surfaces to a dull finish and remove dust.
• If mould is present, clean the surface with household bleach, rinse well with clean water and allow it to dry before further application.
• Ensure all new concrete and cement surfaces are free from any bond breakers, release agents and curing compounds. Allow surfaces time to fully cure before Cosmocoat is applied.
• Ensure all metal substrates are clean and free from any contaminants and rust before further application.
• If a primer, sealer or undercoat is required, Dan’s Paint recommends Cosmocoat 3-in-1 Prep, which is suitable for a wide range of surfaces.

Application:

• Do not apply Dan's Paint Cosmocoat Voda Enamel Gloss when the temperature is below 10° C, above 35°C, when humidity is high, or if rain is imminent.
• Stir well before and regularly during use with a wide flat stirrer that reaches the bottom of the bucket.
• Apply two even coats of Dan's Paint Cosmocoat Voda Enamel Gloss by brush, roller or spray. The use of quality brushes and rollers will ensure the best results. Allow a minimum of two hours dry time between coats. 

Coverage:

Dan's Paint Cosmocoat Voda Enamel Gloss will cover approximately 14 square metres per litre depending on substrate porosity, texture and type of application method used.

Drying and re-coating:

Dan's Paint Cosmocoat Voda Enamel Gloss will be touch dry in approximately 30 minutes in normal conditions. Re-coat after a minimum of 2 hours. Dry times will vary in cold or humid conditions.

Cleanup:

Cleanup with water. For further information on Dan's Paint Cosmocoat Voda Enamel Gloss, surface preparation, application or other Dan's Paint products, contact PaintAccess' experienced customer service team.