Taubmans All Weather Semi Gloss - 15L - White Exterior Paint - New Product!

Taubmans All Weather Semi Gloss - 15L - White Exterior Paint - New Product!

$205.00
financing available

or 4 payments of $51.25 AUD with Afterpay Info

or 4 payments of $51.25 AUD with Afterpay Info

Taubmans All Weather Semi Gloss White Exterior Paint  Semi Gloss Perfect for exterior walls (suggested for roofs, weatherboards and trim), cement render / masonry, timber, galvanised iron, PVC piping and...
Color
Vivid White
White On White
Lexicon
Lexicon Half
Lexicon Quarter
Natural White
Off White
Whisper White
Berkshire White
Antique White USA
Chalk USA
China White
Hog Bristle
Stowe White
Sandy Day
Seed Pearl
White Polar Half
Snow Season
Snow Seasons Quarter
Snowy Mountains
White Exchange Half
White Swan
financing available

or 4 payments of $51.25 AUD with Afterpay Info

Taubmans All Weather Semi Gloss White Exterior Paint 

Semi Gloss


Perfect for exterior walls (suggested for roofs, weatherboards and trim), cement render / masonry, timber, galvanised iron, PVC piping and steel. Not suitable for collecting drinking water surfaces. Gloss level: 20 - 25%.

 

 

Surface Preparation

  • Surfaces must be clean, dry and free from all surface contamination.

  • Treat mould with bleach then rinse with fresh water.


New Work

  • Timber - Weathered (greyed) timber MUST be sanded to the original timber surface. Tannin rich timbers such as cedar should be primed with Taubmans 3 in 1 Prep or a suitable Taubmans oil based wood primer.
  • Galvanised Iron - Thoroughly degrease new surfaces. Weathered surfaces should be thoroughly cleaned before painting.
    For structural galvanised iron, abrade with 240 grade paper to remove chemical treatments and allow full adhesion.
    Cement Render/Concrete - Allow masonry, cement render and mortar to cure for 28 days before painting.
    Steel - Remove rust and prime with a suitable Taubmans iron & steel primer or White Knight Rust Guard® Metal Primer.
    ZINCALUME® STEEL - Wash with water and mild detergent. Surface must be clean and dry. Apply one coat of Taubmans 3 in 1 Prep.

 

Repaint


  • Remove all loose and flaking paint. Spot bare areas with Taubmans All Weather Exterior Low Sheen or the appropriate primer. Apply Taubmans 3 in 1 Prep to aged enamel systems to provide intercoat adhesion. Thoroughly sand new or unweathered Colorbond.®

 

After Painting

  • Avoid exposure to steam for 48 hours. Surface may be washed after 7 days, but always avoid abrasive cleaners.

  • Coats
    Minimum two coats. Apply a third coat for superior performance (depending on substrate - coverage will be lower on rough or absorbent surfaces.

  • Clean Up
    Water: Scrape excess paint from equipment into a separate container. Wash up with water. Do not dispose of paint or wash water into drains or sewers.

  • Coverage
    Up to 16 square metres per litre (depending on substrate).

  • Recoat
    2 hours at 25°C (allow 4 hours in cold or humid areas)

  • Stirring
    Stir paint with a wide flat stirrer in a circular lifting motion for at least 5 minutes before use. It is a requirement to stir paint before use to ensure that the colour tints are dispersed evenly throughout the paint. Continue stirring at regular intervals during application. Where more than one can of the same colour and product is required for a job, mix the contents of all the cans together to ensure colour consistency.


Do not use at temperatures below 10°C, above 35°C or when humidity is excessive.





Lifetime Garantee

LIFETIME GUARANTEE 

Guaranteed against blistering, flaking or peeling if applied on suitable and properly prepared surfaces, according to painted directions.

Nanoguard Technology

NANOGUARD® ADVANCED TECHNOLOGY

 

 

 

 

Paint Calculator is super feature that gives clear understanding for amount of paint  requires for painting project.  In nearest future we can calculate labour cost for the painting project. Usually for 3 bedroom unit/house required amount of paint for ceilings is 20L  in most cases its flat (bathroom ceilings best to use Mould proof paint or simple low sheen paint, 30 litres of paint  for walls usually its low sheen, and 4-6 Litres for wood work.if its new surfaces you must apply sealer/primer undercoat.
Coverage in most cases around 1L per 10 Square meters Again its for previously painted surfaces only. For new plaster board its around 8 squares per 1 L, and new render is 5-7 square meters per one litre of paint.

Paint Calculator
room
← Go back

Related Product

params.svg
Panel Tool
Float header
Float topbar
Default Boxed Large